Locate a flat soft surface (lawn, deck or bit of carpet on concret floor) Unroll hull onto floor and fit Floor Boards, add a little air to chambers to assist assembly, do not walk on Hull fabric forLearn More »

The new all metal Bridgeport valve core will fit into all Arancia IRBs, but will require a new urethane adaptor (supplied with the craft) for the pump and Pressure Gauge to fit into it.Learn More »

Under inflation or unequal pressure in Hull clambers can result in loss of boat speed/performance or excessive floor board loadings/stress. Recommended procedure for inflating AranciaLearn More »

Deflate craft and remove floorboard assembly, clean floorboards with soapy water, then allow to dry standing up on rear edge.Reinflate craft, first checking the inflation valves still haveLearn More »

Pressure gauges do not need much of a knock to go out of calibration or for the pointer to come off. You can roughly recalibrate the gauge by the following method. This procedureLearn More »

Have replacement valve body on hand ready to fit. Fit GRP Removal tool into Valve body mechanism and unscrew anti-clockwise. The internal nut must be held in place thru the hullsLearn More »